COMPANYHONNORORGANIZATION
　　　Position：Home | Trends
   
GATE: external direct
•； GATE: external direct (opposite side of the hinge). Flow direction should climb over the gasket side.
•； EJECTION: ejector pins (ø； 10 mm) on bosses connected to the wall by a rib (thickness= 3 mm max) and other ejector pins on the bottom in bas-relief.
•； SLIDES: no slides are necessary.
•； MOULD PARTING: use the plane passing through cylinder axis and through the center of lateral appendage.
•； GATE: on the side of cylinder (opposite side of appendage).
•； SLIDES: nr. 2 horizontal slides:
1. For cylindric internal part，
2. For appendage internal part and for cylinder upper face (to the end of the radius).
•； GATE: external direct (opposite side of the hinge). Flow direction should climb over the gasket side.
澆口：外部方向（鉸鏈對面）。流向須爬過襯墊側。
•； EJECTION: ejector pins (ø； 10 mm) on bosses connected to the wall by a rib (thickness= 3 mm max) and other ejector pins on the bottom in bas-relief.
澆鑄：通過筋板(最大厚度= 3 mm)連接到墻板上的模板上的頂桿(ø； 10 mm)和在型腔底部上的其他頂桿。
•； SLIDES: no slides are necessary.
滑塊：不需要。
•； MOULD PARTING: use the plane passing through cylinder axis and through the center of lateral appendage.
模具分型面：利用通過圓柱軸線和側面附加件的中心的平面
•； GATE: on the side of cylinder (opposite side of appendage).
澆口：圓柱的側面（附件的對面）
•； SLIDES: nr. 2 horizontal slides:
滑塊：2號水平滑塊
1. For cylindric internal part，
圓柱內部件
2. For appendage internal part and for cylinder upper face (to the end of the radius).
附件內部件和圓柱頂面（到圓弧的端部）
PYRIGHT @ Fujian Fuzhou Chengchang Machinery Co,.Ltd ALL RIGHTS RESERVED
WEBSITE：www.itreduceri.com
 
色婷婷亚洲婷婷7月_亚洲国产黄在线观看_在线视频制服丝袜中文字幕_人人妻人人澡人人视频